Hints On Proper Rubber Stamping.
To ink a surface to pass a message a rubber stamp is used. Stamping can be done on a piece of cloth, board or a paper. The message conveyed on the stamp can either be permanent or temporal. It will be advisable to look for ideal rubber stamps depending on the purpose of the work it should do. There are various types of rubber stamps, and it is essential to use the most creative rubber stamps or custom rubber stamps. Below are some of the steps towards perfect rubber stamping.
It is compulsory to have ink applied on the rubber stamp for it to work. Have ink applied on the surface of the rubber stamp based on its size. For the whole surface to be covered with ink ensure that you press it tightly under the ink pad.
A The user or the rubber stamp must have a picture in mind of the expected results. The final results will rely on the initially created an impression on the users’ mind. The user may decide to press the rubbers stamp downwards and then lift it up straight. This avoids the ink from moving to unintended regions.
Stamping on paper calls for the use of embossing powder. Embossing powder should be put on the places in which ink has been applied. Any excess powder should be removed by flickering a finger at the backside of the paper. A dry brush may also remove the excess powder.
The user may not be in a position to afford the readily available materials making him selective hence economical. Any excess embossing powder can be saved for later use . A scrap paper can be used to have the excess embossing powder recollected. A un doubtful system has to be followed so that there will be no errors.
For the ink to stick permanently, heating has to be done. Heating should be done carefully and quite far from the source thus avoiding any damages. Damages caused by the heating process will not occur at any instance. Good results will be obtained where heating is done under precaution.
Different rubber stamps are used for varied uses. As people will have to use stamps always, they need to know how to rubber stamp. Though the uses of rubber stamps are different, the process of using a rubber stamp remains the same. It is important to note that the rubber stamp to use must be well selected for the specific job it will be used in. Consultation has to be done when the user does not know how to use the stamp.